Message:   Standard Size Balloon

From: zappaz1     Sent: December 7, 1999     Message 1 of 10

Hi Flormo, In regard to your question, I just pulled a balloon out
of a standard cuff. It has a rectangular shape and is flat. It
measures 8.5 inches long and has two tubes 21 inches long connected
to its side. The distance from one end of the rectangular flat bladder
to a tube is 5.5 inches... so if inserted "up to" the tubes as some do,
it will not be inside the full 8.5 inches. The edges of the rectangle
could be called seams but they are not thick seams.

I now roll the bladder sideways into a roll, making the width of
the bladder less than an inch across and still 8.5 inches long. I hold
the middle of the bladder with fingers of one hand around the middle,
and start pumping with the other hand (after turning the twist knob
clockwise). At 16 pumps or squeezes it starts unrolling and is
about unrolled at 20 squeezes but is very loose and I can squeeze it
to less than an inch across easily. At 30 squeezes it is 3 inches across
and I can tighten my fingers around it and make it 2.5 inches or less
across.. with just moderate tightness. At 40 squeezes it is 3.5 or so
inches across and I can squeeze it to 3 inches across. Tight squeezing
of the short end where the tubes would be outside the vagina will let
me enlarge the lower part where it would be inside the vagina up to
4 inches across... depending on how tight I squeeze. Some love doing this.

I will now expand it past where most would stretch to... just to test it.

At 140 squeezes, it is 22 inches around and squeezing on one end makes it
23.25 inches round below the part squeezed. It is much more globular
in shape, but still oval. Very tight squeezing with both hands around it
in the middle allows me to squeeze it to be only about 17 inches around
at the point of the squeezing. At 200 squeezes it is 26 inches around
and becoming more like a ball. At 300 squeezes it is 30 inches around
and very much ball like. At 400 squeezes it is 33 inches around and
I try to compress it with "tight squeezing" between my knees but only
mash the ball to about 7 or 8 inches across between my knees. I can not
burst or break it. I am now tired of pumping it and let the air rapidly
out by pulling off a hose from the connection to the squeeze bulb. After
35 seconds all the air is gone and it measures exactly the same flat size
it was before I started. It would have gone down much slower if I let
the air off by turning the twist knob counterclockwise.

So that may give you some idea of what it does.

A few women with very deep vaginas will take the entire standard size
balloon before much stretching of their opening happens... because the
outside part will just move or "jump inside" into their deeper vagina,
as it gets bigger. I knew of one huge lady who bought a larger size so
it would not jump inside her as she filled it. This allowed her to
insert the balloon rolled around a blunt rod to the full depth of her
vagina and then when she pumped it up, she still had some of the balloon
stick outside of the vagina. This allowed her to practice stretching her
vaginal opening as she filled the balloon instead of just swelling it
larger with the entire balloon inside the opening (but most would not
need the large size balloons that are made).

The vaginal moisture the balloons stimulate tends to make them get very
slick and they can sometimes even shoot out with straining and
"tightening up" upon them.

zappaz1